New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have a 12mm x .8 x3 triple start set of die and tap from Mike Redburn. I have wondered, since using it, if a bottoming tap would be a useful addition as it would allow a neater finish to the cap thread - particularly if using translucent or semi transparent material. Does that make sense?

[QUOTE="davidj44, post: 211824, member: 211"] I have a 12mm x .8 x3 triple start set of die and tap from Mike Redburn. I have wondered, since using it, if a bottoming tap would be a useful addition as it would allow a neater finish to the cap thread - particularly if using translucent or semi transparent material. Does that make sense? [/QUOTE]

Verification