New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Mine is only a small saw turning on 2 x 6" wheels, I dunno if I would trust silver solder to be strong enuf.
But that ain't the point, the point is "fit for purpose" these are brand new not reconditioned or at least that's what I paid for and that's what I expect.
Each blade has to be set for it's own use and getting 4 x 4" cuts simply is not good enuf init?

[QUOTE="Grump, post: 206792, member: 232"] Mine is only a small saw turning on 2 x 6" wheels, I dunno if I would trust silver solder to be strong enuf. But that ain't the point, the point is "fit for purpose" these are brand new not reconditioned or at least that's what I paid for and that's what I expect. Each blade has to be set for it's own use and getting 4 x 4" cuts simply is not good enuf init? [/QUOTE]

Verification