New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have 0% interest in turning plastics, but do have curiosity.

We have some injection moulding plastic granules at the school, and I mixed a couple together to see what happened!

Here is the result.

[ATTACH]17919[/ATTACH]

It is hand rolled and is 4 1/2" x 3/4" at its thickest point.

If you fancy a go at turning it, just let me know and it will go in the post!

[QUOTE="Neil Lawton, post: 175384, member: 365"] I have 0% interest in turning plastics, but do have curiosity. We have some injection moulding plastic granules at the school, and I mixed a couple together to see what happened! Here is the result. [ATTACH]17919._xfImport[/ATTACH] It is hand rolled and is 4 1/2" x 3/4" at its thickest point. If you fancy a go at turning it, just let me know and it will go in the post! [/QUOTE]

Verification