• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I am trying to make a hole 40mm Dia. by 7cm long. When I reach about 4 to 5 cm long the wood and bit gets hot of even on a low speed of 500 rev.

It struggles to carry on drilling, I keep removing the bit to clear the waste wood but within seconds it struggles again. I am wondering if I need a better Forstner Bit. Ideas please

Glen:sob:


Top