• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Vacuum Chamber

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
Has anyone on here made their own vacuum chamber?- Looking for some guidance on what to buy.
Thanks
 

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
I assume you are stabilizing. I use a one gallon pickle jar. 1" thick corian lid with neoprene seal.

Hi Terry

Can I ask did you tap the corian and screw the fittings in or did you just rely on a bit on the underside to tighten them in?
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Suck it up Ian its a slippery slope,beware pressure and suction work carries strict laws for commercial work for very good reasons.Have a good gaze on the IAP in USA Library.

Peter.
 

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
Im thinking of using a pickle jar with a clip top type lid and replacing the glass lid with corian turned on the lathe to the same profile and fitted with the rubber seal so I can utilise the steel wire clip to give a compression seal to the jar.

I cant decide what pump to buy - looking at quite a number of far eastern ones on Ebay for about £100. Any members of the forum bought one in UK which they can recommend? Also looking at used branded pumps, but I suspect they could be as likely to fail as a new Chinese one?

Thanks.
 

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
I assume you are stabilizing. I use a one gallon pickle jar. 1" thick corian lid with neoprene seal.

Terry,

I assume its advisable to get a pickle jar that's as tall as possible to avoid pulling resin into the pump when it foams up?
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Now on with the motley,lucky there are local dealers for the chemistry needed. Interesting to amortise the cost needed to achieve results including purchases. But then thats part of the solution.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top