• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Finally determining an accurate size in a hole I under drill in size then use a small end mill to cut to fit, I did this for years making my own mandrel savers works for me. Have never trusted drill sizes always mike them.


Peter.


Top