• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Turned these bits down nicely round, all looking good, sand gently 240 through to 2500 and somewhere in that process these dirty marks appear......any clues as to what's occurring?  It didn't happen at all on the first few pens I made but now it seems to crop up on every one.  It's getting a bit expensive on tubes...... :sob:


Any and all thoughts very much appreciated.


Top