New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I overcome this problem by turning some disposable bushes out of delrin. I use the metal bushes to turn the blank(s) to size and then exchange them for the delrin bushes before I begin sanding. I also use abranet and micromesh to prevent bits becoming detached from the grit and embedding themselves in the wood. This solves the problem.

[QUOTE="Bob Ellis, post: 232587, member: 782"] I overcome this problem by turning some disposable bushes out of delrin. I use the metal bushes to turn the blank(s) to size and then exchange them for the delrin bushes before I begin sanding. I also use abranet and micromesh to prevent bits becoming detached from the grit and embedding themselves in the wood. This solves the problem. [/QUOTE]

Verification