• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I do hope to go down the path of triple lead tap and die but not just yet.


so to date the tools I have bought for kitless pen's

collet chuck

sliding die holder

tap for section 10x1 mm

Tap and die 14x1 mm for barrel and cap will be upgrading later but this will have to do for now (practice)

drill chuck

I have ordered a section sleeve for my first pen

Bok #6 to fit the above sleeve

Acrylic blank

nylon rod to make a mandrel for barrel and cap.


I have some carbide chisels from Amazon  I was wondering if I can turn brass with them for a better mandrel.

do I need anything else for a kitless pen


James


Top