This would of been a nice pen except for one thing, the pen is too small for the blank!!!
I thought I was making a Zeta and drilled a 9mm hole in the blank, the zeta bushes fitted perfectly in the tube.
When it came to assembly I could push the bits in with absolutely no resistance, I tried another zeta kit on the blank and the same happened.
I have ended up super gluing both ends to stop them falling out.
Todays lesson learnt (well 2 days really) was to check the parts with the tube before drilling. I have checked the other Zeta kit I have and there is resistance when pushing the end in, I will get that drilled and turned over the next few days.
Zeta Pen
Mr Resin Blank
Dry Abranet sanded to #600
Wet and dry pads (Wet)
G3
Super Glue (To keep it all in place)
I thought I was making a Zeta and drilled a 9mm hole in the blank, the zeta bushes fitted perfectly in the tube.
When it came to assembly I could push the bits in with absolutely no resistance, I tried another zeta kit on the blank and the same happened.
I have ended up super gluing both ends to stop them falling out.
Todays lesson learnt (well 2 days really) was to check the parts with the tube before drilling. I have checked the other Zeta kit I have and there is resistance when pushing the end in, I will get that drilled and turned over the next few days.
Zeta Pen
Mr Resin Blank
Dry Abranet sanded to #600
Wet and dry pads (Wet)
G3
Super Glue (To keep it all in place)