New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Hi Alan, the piece I had was 140cm x 45cm and 4.5cm thick it had been kiln dried and was at 17% moisture when I got it so wasn't too bad. That was until I started to make some boxes out of it, then it wanted to move in all directions. I still have one that has been made up that now has a lid with a 2mm gap on one side.

[QUOTE="silver, post: 360829, member: 165"] Hi Alan, the piece I had was 140cm x 45cm and 4.5cm thick it had been kiln dried and was at 17% moisture when I got it so wasn't too bad. That was until I started to make some boxes out of it, then it wanted to move in all directions. I still have one that has been made up that now has a lid with a 2mm gap on one side. :rolling: [/QUOTE]

Verification