• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Zeta dressed in Cranberry Crush

webby962

webby962

Full Member
Joined
Jun 29, 2016
Posts
114
Location
Nr Letchworth
First Name
Adie
First time I have used the new Bosch Pillar drill to drill out the blanks. I have to say it was a lot easier than when I did it on the lathe, so I'm a happy camper now :-)

29457.jpg
 
Bill Mooney

Bill Mooney

Blind old git
Grand Master
Joined
Aug 16, 2014
Posts
11,096
Location
County Durham
First Name
Bill
Now that's a good looking pen. It's a personal choice but I was taught to follow the nib angle through to about mid way of the blank then reduce to the clip end diameter to give a pleasing shape & as far as I can see you've done just that. Well done. :thumbs:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top