There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
Here’s a little matching pair.
Bolt action Pen in a nice acrylic with a shotgun cartridge matching
keyring with the leftover blank. And yes I know the pin is at the wrong end,
as I drilled the brass to fit the ring holder I didn’t want to waste it.
A little fun with wood and brass...
Walnut with partially stamped out mini connectors and bethlehem olivewood wirh watch parts and a Rado faceplate.
Comments and critique welcome as always
Best regards,
Tom
A few glue ups untrimmed yet then ready to turn. All Slims to be,got a fright with one of them the brass was from a special pen kit that sported a longer base than any others designed by Dick Sing and marketed in the US so long ago and one brass protruding locked up in the glue up so It will be...
Hope you like this Bill.
This is the second project with a bullet case. I would of liked to replicate the wave of the flag but that is a little more complicated.
The Brass case has been dipped once in Rylards brass lacquer.
Brass case pen. - YouTube
Hi Everyone,
I just kinda got into Milliput and I'm knocked out with some of it's
possibilities.
I just wondered, silly as it sounds, if anyone had applied
Milliput directly to the brass tube and lathed it down from there.....
Regards - Jim:drool:
Not sure if anyone in here can help but it doesn't harm to ask & I know people will do other things apart from turning pens lol
May have a job where I would like to inset a brass square (100mm) into the top of a post, I can pocket the top of the post out easy enough so the brass plate sits...
Ive had my first customer message me with a problem with their pen and I have made and sold many - its a TM Kappa and it appears the threaded piece which is press fitted into the brass tube into which the section threads has come out of the brass tube.
Has anyone else had this happen? Should I...
.410 bore, 2.50" chamber brass shotshell casing on an Antique Brass 30 cal Bolt Action.
Finished with 6 coats of lacquer to avoid tarnishing and the toned down the shine with
Oil Free Ultra Fine Steel Wool.
Les
Hi All,
I made a friend a walking stick some time ago. It had a brass handle and a brass spigot/joint in the middle of the Oak stick with a rubber cover at the bottom that you took off to show a brass point which was a help in winter weather.
I want to make another but I can't find a stockist. I...
Hi after having a bit of a tidy up in the shed I found some spent cartridges in my shed .243 and .270 Winchester magnum. Looking at the .243 I thought it looks the same lenth of the brass tubes from a slimline and remembering a utube video from Woody decides to drill out the primer first with...