7.62 Part Two

[Woody]

Got hold of a few bullet cases this morning, my partners son has loads of them. So dying to give this a go now. Thanks for that Paul.

My only issue is I don't have a dremel, so will have to file the notch for the clip I guess

I file mine Rob it only takes a few min

 

[paulm]

I file mine Rob it only takes a few min

It is an excuse for a new toy though!.... just a thought

 

[Grump]

A good tut Paul and nearly right too.

 

[paulm]

A good tut Paul and nearly right too.

Its funny but coming from you, that seems like a compliment

Hows the job hunting going?

 

[Grump]

Its funny but coming from you, that seems like a compliment

Hows the job hunting going?

It is a compliment, I would do a few things differently but to the same end init?
Job hunting on hold while I enjoy some sun sea and sand in Majorca.
I just pop in here to keep tabs on the Gay community init, make sure they don't overstep the mark with the Tom they're sticking on?
Can't have the standards dropping too far you know?

 

[paulm]

Ah, I thought we were being under grumped, you're out drinking San Smiffs. Have a nice time and have one for me

 

[Robert]

Use a Dremel to cut a notch in the end of the top cap

View attachment 8078

I don't have a dremel, and don't want to buy one just for this.

Is there a drill attachment I can buy to do this job? Any suggestions?

 

[wm460]

Got hold of a few bullet cases this morning, my partners son has loads of them. So dying to give this a go now. Thanks for that Paul.

My only issue is I don't have a dremel, so will have to file the notch for the clip I guess

I dont either but the Missus got one and it lives in the shed now, not that she know yet.

It gets used for a number of thing now a worth while investment.

Great tutorial Paul

 

[Grump]

The dremel parts will fit a standard 13mm Jacobs chuck you just have a bigger chunk to move it with.
If I remember right they are something like 2.6mm smallest arbour and a Jacobs should close to that no worries.

 

[Buckeye]

Use a hacksaw and a file.

Peter

 

[Jim]

Paul, did you make a PDF of this tutorial?

 

[Bill Mooney]

Nice tutorial Paul, I'll have a go at this.

 

[rayf6604]

I'm in the middle of making one of these using this tutorial and I have to say that so far it's been a sinch to follow and a perfect tutorial. I'll post the result when I've finished it hopefully tomorrow.