• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Advice on Chucks and Jaws

Lons

Lons

Fellow
Joined
Dec 17, 2013
Posts
4,758
Location
Northumberland
First Name
Bob
21William said:
That’s a coincidence, I have the Record SC3 and the Axminster SK100. Very different chucks but I like them both.
Click to expand...

Hi William
Mostly I keep the G3 on my little jet lathe although I have an adapter to fit the Axi 1416 as well so for convenience my drilling is done on the jet.

When I bought the Axi lathe I had planned to sell the jet bot was advised by several forum members to hold on to it, one of the best bits of advice I've ever received although not everyone can justify or have the space to accommodate 2 lathes.
 
Penpal

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
The recommended drill sizes for a lot of pen kits can be iffy I found recently you could drive a horse and cart in between the brass and timber. Getting to where I check and adjust all the way with calipers.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top