• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Bushings for the JR Gent

Woody

Woody

Registered
Joined
Jul 12, 2013
Posts
12,812
Location
at home
First Name
no
I trim one end on the lathe after drilling I then swap the drill bit for a fostner bit and slowly wind it on to the pen blank and trim it has to be square the other end I do on a sanding disk on the lathe with a flat platform in the toot post
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top