• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Idea to pen inlay: CNC software steps

clumsysod

GOBBY GIT
Graduate Member
Joined
Apr 7, 2013
Posts
687
Location
Grantham
George those bikes look the bizz, and very clear to make out ... :bwink:

I am getting there Jim but poke the inlays, far too fiddly for fat fumbly fingers.
I'll stick to scratching maybe a few pens if I can master it.
Holding the damn things is the next battle to overcome, without damaging them.
No such thing a vice here I have made one from a couple of bits of wood and some long bolts but Heath Robinson, any suggestions David?
What do you hold your work with while spinning a nail at 1000 rpm?
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top