• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Not bad for the first attempt

Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,708
Location
Kent
First Name
Derek
Could that mould also be used for the gents JR pen. Waiting to see them for sale
 
Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,708
Location
Kent
First Name
Derek
I knew the diameters are the same but could not remember which was the longer one of the two. Thanks Dan.
 
TaylorsMirfield.co.uk

TaylorsMirfield.co.uk

Registered
Joined
Apr 22, 2014
Posts
2,253
Location
Mirfield
First Name
Dan
4f4d9ed29f079636ed90d6d2be33d10f.jpg
 
paulm

paulm

grave manibus faciendum
Registered
Joined
Oct 7, 2013
Posts
12,046
Location
Sandford
First Name
Paul
That looks very good to me Dan, I like that there is space at the end of the tubes as some fit just right and under pressure goes into the side wall and so is short one end and long the other
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top