There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
I don't know the lathe but I have used Picador bearings and plummer blocks. As far as I know Picador Engineering still exist in Grimsby - they may be able to give you detailed in formation on the lathe. I think they used to sell kits for the home construction market
Why i am asking is that i picked up a few tools that i bought off ebay, and some picador parts are in with them so i was curious as all the parts had the Picador name and part number on them. So when i searched to see what it was i found this drawing...
Looking at that picture Jim I think it may have been made by Coronet.
Peter is an expert on these and may be able to cast some light on your inquiry. BoleynWorkshop Coronet lathes