There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
This is a PSI 'Tudor Twist Pen'.
In pics I've seen of the kit, makers tend to have the body barrel in plain curves.
I thought I'd try and make it a bit more interesting.
I wanted to offset the heavy cap fitting and the ornate metalwork with some heavy turned detail and weight in the barrel.
To...
Had a good day today and finished all the pens my work colleagues asked me to make. The golfers pen is turned using hickory from an old golf club. The FAT slimline is spalted beech and the medical one is unknown to me?????
Craig:thumbs:
Good morning, all. I am in writing to pick the brains of those working without kits.
I want to be able to add metal rings to the bodies and caps of my fountain pens. I have done turned contrasting rings by boring the cap, making a tenon on another piece to insert, and then adding contrasting...
Here are two om polymer clay pens made from Toni Ransfield blanks.
The first pen is polymer clay 7mm tubes cast in clear resin & turned to my usual shape. The second is a standard slimline Pen.
Hi All,
This is part 1 of 2
A very short video of my first try with Polyclay.
This piece of cane was handmade and is amazing to look at.
I managed to ruin it in about 5 minutes. ;-)
I'm hoping it will look a little better when turned.
Polyclay cane & Resin - YouTube
Another commission. The customer didn't want a clip that looked kike a gun - I can't say I blame him - so some may remember I was asking around a while ago about bullet pens that the clip could be removed. Between us, the customer and I eventually plumped for an Over and Under (its a PSI kit...
I’ve made 19 of these snowmen for table decorations.
They are made from a scrap of beech mop stick handrail. The heads & hats are turned from the same timber. They were decorated by Evelyn.
So .... today I turned two slimline pens and they seemed absolutely fine... I will post photos when I take some...
Then I turned a blank for a bolt action and it’s so off true you could trip over it...
I have asked a question about disassembly of that on another thread but how can the above...
Hi All,
My first bottle stopper.
Not too bad. Next time I will make sure the screw goes into wood rather than the resin.
Pinecones look amazing when turned.
Pinecone & Resin - YouTube
This weeks Pen of the Week chosen by GeordieB goes to the Guns n Roses Bullet Pen made by Walter Hall.
George said "This pen really stood out to me, everything about it shouts class. Turned, finished and photographed beautifully. This pen is stunning
Here is the link to Walters original post...
Hi all
Last week I had the opportunity to visit Bill who as it turned out lives near to me and had kindly responded to my earlier question as a newbie on how to finish pens...
I turned two wooden ones and an acrylic and here are the three that I finished following his methods and...